SMR Gearbox Set up

SMR Gearbox Installation
Satisfactory functionality is determined by appropriate set up. lubrication and upkeep. for that reason it is vital the guidelines within the set up and maintenance leaflet. supplied with just about every gearbox. are followed carefully. a few of the significant aspects of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as near to the reducer possible, and mount reducer on driven shaft as shut to bearing as practical. failure to complete this may cause extra loads during the input shaft bearings and output bearings and could induce their premature failure.
two. Install motor and wedge belt drive with the belt pull at around 90° for the center line involving driven and input shafts. this may allow tensioning on the wedge belt drive together with the torque arm which should really ideally be in stress. if output hub runs anti-clockwise. torque arm ought to be positioned the best.
3. lnstall torque-arm fulcrum on a rigid help to ensure the torque-arm will probably be at about ideal angles to the center line through the driven shaft plus the torque arm situation bolt. ensure there is certainly sufficient take up inside the turnbuckle for belt stress adjustment.
Maintain shut.
Bell drive could be positioned in any handy postion. if your torque arm should be to be made use of to tighten the belts, the drive ought to be at about tight angle to your line in between the input and output shafts.
Bell drive may very well be located towards the correct if preferred.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown within the illustration.
Torque arm and belt consider up.
Torque arm may very well be mounted on the proper if preferred.