Energy UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Basic Description
This energy unit is intended solely to the modest lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit continues to be broadly utilized from the business of logistic units which include minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is controlled through the solenoid valve together with the speed managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is intended exclusively for the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and also the velocity controlled from the adjustable needle valve. Once the lift rises to a higher positoin, however the electrical power provide is minimize, the decreasing motion is managed from the manual override perform.
Energy UNITS FOR LIFT TABLE three
Standard Description
This electrical power unit is intended exclusively for that huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as velocity controlled by a pressure compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is made solely to the significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as velocity controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the energy provide is reduce, the reducing motion is controlled from the manual override perform.
Exclusive Notes
one. This power unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic elements concerned before installation of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which should really also be clean and absolutely free of impurities.N46 hydraulic oil is proposed.
four. Oil shifting is needed after the initial 100 operation hours,afterwards when just about every 3000 hrs.
5. The power unit shown is created to be mounted vertically.